|
Post by 324736214 on Oct 3, 2015 12:28:29 GMT -5
I set "terminal turn" parking spots in the airports I am backdating (SBGL, SBRJ, SBSP, and SBPA). AI was behaving accordingly, leaving the spot moving ahead. Suddenly in all airports planes started to disappear, simply that. As comes the time scheduled in Traffic Tools explorer, (generally with 1 minute delay) the plane simply disappears. Very strange...
Regards
Walter
P.S: when there is no parking spot available, it disappears at landing, still in the runway, but this I know is normal.
|
|
|
Post by emfrat on Oct 3, 2015 15:35:07 GMT -5
Make sure there are no gaps in the network of Parking-Apron-Taxiway and Runway links. If there is a gap, the plane does not know what to do so it stops. That means it can't meet the scheduled arrival time at the destination, so it 'disappears' from the starting airport and will reappear in the air somewhere between the two airports. This can also happen if the schedule is too tight. AI needs about 20 minutes each end for start-up, taxying and so on. You need to allow for that at each stop, otherwise the plane will start missing a stop in order to meet schedule at the next stop.
|
|
|
Post by 324736214 on Oct 3, 2015 16:18:22 GMT -5
Thanks for the info, I will check all those things.
Best regards
Walter
|
|
|
Post by Tom/CalClassic on Oct 3, 2015 19:58:07 GMT -5
Hi,
Yes, check the linkages between parking spot, taxiways, and runway. And make sure to have a red hold short node within 200 ft of the runway at the entrance.
Finally, make sure you have black runway links down each runway AND check that they have the right runway name on each one.
|
|