|
Post by discoazul2000 on Jul 3, 2020 12:39:06 GMT -5
Hello, I can't get the default Q100 to land at KTEX. It approaches from the runway 27 side and misses it all the time. It's not realistic because the Q100 lands in Aspen, KASE, which is even worse as far as the proximity of the high mountains on the approach. It might be able to do it at KTEX from the other side, i.e. runway 09. I tried making runway 27 closed for landings but I was not able to trick the system. Is there another way to force the aircraft to land from the runway 09 side ? Thanks in advance. Cheers.
|
|
|
Post by Tom/CalClassic on Jul 3, 2020 15:31:42 GMT -5
Try removing the start location for runway 27.
Otherwise change the wind to favor runway 9.
|
|
|
Post by Dennis the menace on Jul 5, 2020 2:03:51 GMT -5
In addition to what Tom has said, if you can put it into ADE, remove all the approaches to 27. There is no way to "close" a runway. Runways operate on a "priority" system. I close that end for take off and landings. I remove the start locations. I remove all approaches to that runway. You want the AI to use Runway 9, so check to see if that has an approach. If it does not, then use ADE to add a simple approach. All these things will give that end a higher priority than the other end.
|
|