Post by Tom/CalClassic on Dec 4, 2019 13:34:33 GMT -5
Note that the only error I can find is that the gauges are a little offset in the VC. I don't know what causes this error, and I don't think it can be fixed. It appears that the gauge polygons shifted forward a small amount during conversion.
Post by Tom/CalClassic on Dec 5, 2019 1:18:33 GMT -5
If you move around the VC you can see that if you are exactly opposite a gauge it's actually in the correct location. When you are above/below/left/right of the gauge you can see the offset. The gauge face is a few inches forward of the panel itself.